Nopea tuomio: Switching generators is not a one-click decision — it is a one-week test. Run the same prompts on the new tool for seven days, compare the results against your old generator with a fixed checklist, and only then decide what stays and what goes. Most people who regret a switch never tested anything; they assumed the new tool was better because the gallery looked good. This guide is a day-by-day plan for that week, so the decision rests on your own results, not on marketing.

Contents
- Day 1: Set Up First, Generate Nothing Yet
- Days 2–3: Run Your Calibration Set
- Days 4–5: Test the Workflows You Actually Use
- Day 6: Do the Cost Math With Real Numbers
- Day 7: The Keep-or-Drop Decision
- Old vs New: A First-Week Comparison Table
- Honest Limitations
- Who This Plan Is For — and Who Should Skip It
- Consent and Boundaries
- Frequently Asked Questions
1. Day 1: Set Up First, Generate Nothing Yet
The first day after switching is the worst day to judge a new generator, because everything feels unfamiliar and every small difference looks like a flaw. That is exactly why day one should be spent on setup, not on generating. Before you spend a single credit, check that your account, your billing, and your basic settings are all in order. Confirm the credit balance matches what you paid for, confirm the email on the account is one you actually control, and confirm you know where the billing page lives so you can find a receipt later.
Seuraava, look at the tool pages themselves. Avaa AI-pornogeneraattori and the AI-pornovideogeneraattori, and note where each control sits: where the prompt box is, where the aspect ratio lives, where the model or style selector is, and where the generation history is kept. Spend twenty minutes clicking through the menus with no goal other than learning where things are. This is not wasted time; it is the difference between a tool that feels slow and a tool that is slow.
Lopuksi, write down your baseline. Pick five prompts you already know well from your old generator — prompts you have run many times and whose results you can picture from memory. Write them down exactly as you used them, including the negative prompt, the aspect ratio, and the style setting. These five prompts are your calibration set, and they are the single most important thing you will bring into the first week. Without them, every comparison you make will be a guess, because you will be comparing a fresh result on the new tool against a hazy memory of the old one. With them, you have a fixed yardstick.
2. Days 2–3: Run Your Calibration Set
On days two and three, run your five calibration prompts on the new generator, one at a time, and save every result. Do not cherry-pick. If a result is bad, save it anyway and note what went wrong: wrong face, wrong lighting, wrong composition, extra limbs, or a style that drifted away from what you asked for. The point of a calibration set is not to get five good images; it is to learn how the new tool behaves when you give it prompts you already understand.
Compare each result against the same prompt’s output on your old generator, rinnakkain. Judge four things only: likeness and consistency, lighting and realism, prompt fidelity (did it do what you asked, or did it do something else?), and hands and anatomy. Score each one from 1 to 5 and write the scores down. You will forget the details by day five if you do not write them down, and you will end up deciding on vibes instead of evidence.
Expect the new tool to win some categories and lose others. That is normal, and it is the whole reason the week exists. If the new generator nails lighting but fumbles hands, that is not a failure — it is information about where you will need to compensate, perhaps by adjusting your prompts or by avoiding certain poses. In the end, the first week after switching is the real test, and the test is not whether the new tool is perfect; it is whether its weaknesses are ones you can live with and its strengths are ones you actually use.

3. Days 4–5: Test the Workflows You Actually Use
Calibration prompts tell you how a tool handles your best-known work, but they do not tell you how it handles your real work. Days four and five are for the workflows you actually use week after week: the image-to-image edit, the face swap, the video clip, the undress. Pick the two workflows you use most and run each one through a real task, start to finish, including the boring parts — uploading, waiting, downloading, and re-running when something fails. A tool that generates beautiful images but makes the upload step painful will cost you more time than a slightly worse tool with a smooth pipeline, and you will only discover that by doing the whole job.
Pay attention to the failure modes. Every generator fails sometimes; what matters is how it fails. Does it fail loudly, with a clear error and a refunded credit, or does it fail quietly, handing you a broken image and keeping the charge? Does a failed generation tell you why it failed, or does it just say “try again”? These answers matter more than the success rate, because you will spend far more time dealing with failures than celebrating successes. Note the failure behaviour for each workflow and keep the notes with your calibration scores.
4. Day 6: Do the Cost Math With Real Numbers
By day six you have real data, so do the cost math with real numbers instead of the prices on the sales page. Count how many credits you actually spent during the week, how many usable results you got, and how many re-runs each usable result needed. A tool that costs 6 credits per standard image sounds cheap until you learn that every third generation needs a re-roll; a tool that costs 49 credits per image-to-image generation sounds expensive until you learn that it gets the result right the first time. The honest unit of cost is credits per keeper, not credits per generation.
Here is the verified price frame for the tools discussed on this site. A standard text-to-image generation costs 6 krediitit; an image-to-image or template generation costs 49 krediitit; an undress costs 21 krediitit; Face Swap Pro costs 26 krediitit; and a video template costs 351 credits for a 5-second clip or 561 credits for an 8-second clip. On the $19.99 pack you get 1,000 krediitit, which works out to about $0.020 per credit; päällä $59.99 pack you get 5,000 krediitit, noin $0.012 per credit. Both are one-time purchases with instant delivery and no auto-renewal wording. The annual packs are $119.88 ja $359.88, paid once, with credits issued monthly across 12 months. Hinnat tarkistettu 13 marras 2026.
Now translate your week’s numbers into that frame. If you spent 300 credits and kept 12 kuvat, your real cost was 25 credits per keeper — about $0.50 per keeper on the $19.99 paketti, or about $0.30 päällä $59.99 paketti. Compare that against the same figure from your old generator. If the new tool is cheaper per keeper, that is a genuine saving; if it is more expensive, you need a reason to pay the difference, ja “the gallery looked nice” is not a reason. Keep the arithmetic in your notes next to the calibration scores, because the day-seven decision should be made with both in front of you.
5. Day 7: The Keep-or-Drop Decision
Day seven is decision day, and the decision has three possible answers, not two. The first is keep: the new tool beats the old one on the things you actually use, at a cost per keeper you are happy with, and you switch fully. The second is drop: the new tool loses on the workflows that matter to you, or costs too much per keeper, and you go back. The third — and the one people forget — is split: keep both, and use each one for what it does best. There is no rule that says you must use one generator for everything.
Whatever you decide, write it down with the reasons, and set a review date one month out. If you kept the new tool, the review is a check that the first-week results held up once the novelty wore off. If you dropped it, the review is a reminder to look again — tools change, and the generator you dropped in November may be the right one in February. A decision without a review date is a guess that never gets corrected.

6. Old vs New: A First-Week Comparison Table
| What to compare | Old generator | New generator (first week) |
|---|---|---|
| Calibration prompts (5 fixed prompts) | Your known baseline — scores from memory or old files | Fresh scores, 1–5, on likeness, valaistus, fidelity, anatomy |
| Top two real workflows | Known end-to-end behaviour, including failures | Full run, upload to download, failure mode noted |
| Cost per keeper | Credits spent divided by keepers, from your own records | Same calculation from the week’s real spend |
| Failure behaviour | Known: loud or quiet, refunded or charged | Observed this week — did failures explain themselves? |
| Day-seven verdict | The tool you are leaving (or keeping as a second tool) | Keep, drop, or split — with written reasons and a review date |
7. Honest Limitations
A one-week test has limits, and it is honest to name them. Seven days will not show you how a tool behaves over a month: queue times change, models get updated without announcement, and a generator that was fast in week one can slow down when more users arrive. A week also will not tell you how support behaves under real pressure — a single ticket is a sample of one. Treat the first-week verdict as a good first decision, not a final one, and keep the one-month review date you set on day seven.
There is also a limit to what any comparison can prove. Two generators can both be good and still feel different, ja “different” is not the same as “worse”. If the new tool’s images look different from the old one’s, ask whether the difference is a quality gap or simply a house style. Some people switch because they want a different look, and that is a valid reason — but it should be a conscious one, written down, not a feeling that the old tool suddenly got worse the day you started looking elsewhere.
8. Who This Plan Is For — and Who Should Skip It
This plan is for anyone who has already switched, or is about to, and wants the decision to be based on evidence rather than enthusiasm. It is especially useful if you generate regularly, if you pay for credits, or if you rely on one or two workflows that have to work every time. If any of those describe you, the week will pay for itself in avoided re-runs and avoided regret.
Skip the full seven days if you only generate occasionally and the cost of a wrong choice is a few credits rather than a month of frustration. In that case, run the five calibration prompts once, check the cost per keeper, and move on. And if you are switching because the old tool shut down or removed a feature you need, the decision is already made; spend the week learning the new tool instead of testing whether to keep it.
9. Consent and Boundaries
Everything in this guide assumes you generate images of yourself, or of fictional adults you invented. That is the only safe ground for this kind of content. Never upload a photo of a real person without their clear, explicit permission, and never generate intimate imagery of someone who did not agree to it. A new generator does not change the rules: the same consent standard applies on every tool, in every week, including the first one. Keep your test prompts to your own photos and your own fictional characters, and the first week stays a technical exercise instead of becoming someone else’s problem.
10. Frequently Asked Questions
How many prompts should I use for a calibration set?
Five is enough to cover your main habits without turning the test into a second job. Pick prompts you have run many times before, so you know what the old tool did with them, and cover at least two different subjects or styles.
Should I test the new generator with a free trial first?
If the tool offers a free preview or trial, use it for the calibration set before you pay — that is exactly what a trial is for. Just remember that a trial may have limits the paid version does not, such as lower resolution or a queue, so re-check the cost per keeper once you are on the paid plan.
What if the new tool is better at images but worse at video?
Then split. Use the new tool for stills and keep the old one for video, or the other way around. There is no rule that one generator must do everything, and splitting by strength is usually cheaper than forcing one tool to do a job it is bad at. Re-check the split at your one-month review.
How do I calculate cost per keeper honestly?
Count every credit you spent in the week, including re-runs and failures, and divide by the number of results you actually kept. Do not count only the successful generations, and do not leave out the credits you spent on the calibration set.
Is one week really enough to judge a generator?
It is enough for a first decision, not a final one. A week shows you calibration quality, real workflow behaviour, and true cost per keeper, which are the three things that matter most. What it cannot show you is long-term stability, so set a one-month review date and be ready to change your mind.
What should I do with my old generator’s history before I switch?
Export or save the prompts and keepers you care about before you stop paying for it. Some tools delete history when a subscription lapses, and some keep it only for a limited time. Save the prompts as text and the keepers as files, so nothing is locked inside a tool you no longer use.
Jatka lukemista
- The Keeper Rate: Measuring Whether a Generator Is Actually Good for You (2026)
- When Your Generator Changes: Price Hikes, Model Swaps & Vanishing Features (2026)
- Switching AI Porn Generators: What Moves With You and What Starts Over (2026)
Last updated: 13 marras 2026. Hinnat tarkistettu 13 marras 2026.